Advantages of Exterior Wall Insulation Rock Wool Board Produced by Rock Wool Production Line

Introduction to the production line for rock wool

• Melting section.

• Cotton collection device.

• Board forming section: Curing furnace and Cutting machine.

Preparing for painting and precautions during painting for the rock wool production line

• Before painting the rock wool production line, check whether the type, model, and specifications of the paint meet the requirements of the construction technology conditions.

• Before painting rock wool production lines, the basic composition, performance, and construction methods of the coating should be understood, and appropriate painting tools should be selected according to the coating's construction requirements.
  

• During the painting of the rock wool production line, there will be different degrees of precipitation because of variations in the proportion of different components in the coating. Therefore, the paint should be stirred until it is uniform before coloring.
  

• Generally, the paint has been adjusted to a viscosity suitable for factory construction and does not require dilution.
  

Precautions for the construction of rock wool board for the rock wool production line

• The surface of rock wool boards in the rock wool production line should be dry and free of grease, and the heating equipment and air duct should be leak-free. Under these conditions, rust and roots should not form, which is beneficial for anti-corrosion.

• In the rock wool production line, in order to reduce the heat loss of various types of connectors, panels, and felts, they should be very close to the bridge pier. The insulation joints between layers should be staggered to avoid thermal bridges and prevent cold bridges.
  

• The insulation of rock wool boards for the rock wool production line is suitable for outdoor use or parts that are easily worn by machinery, such as metal or plastic sheaths. Pay attention to the sealing of the joints. If necessary, a sealant can be added. The sealing layer of the overlapping area should be no less than 100mm.
  

• In cold temperatures, the cold steam barrier of the rock wool board in the rock wool production line should be protected. At very low temperatures, rock wool boards in the rock wool production line are non-resin insulation, and the moisture barrier is fire-resistant.
  

• When the temperature of the rock wool boards in the rock wool production line exceeds 200℃, a shell should be added appropriately to prevent expansion from changing the thickness and bulk density.
  

• For large-diameter equipment flat walls or rock wool production lines insulation board products, insulation nails above 200℃ should be added, and the outer protective covering (spacing 400mm) should be tightly aligned.
  

• When an insulating object is placed vertically, it has a considerable height. There should be locating pins or bearing rings in the insulation layer, and the spacing should not exceed 3 meters to prevent the insulation material from sliding during vibration.
  

• For outdoor applications, attention should be paid to insulation for the rock wool boards in rock wool production lines, and construction should not be carried out in the rain. Otherwise, rain protection measures should be taken.
  

At the same time, when using rock wool boards for construction, operators should wear labor protection equipment, do a good job of occupational health protection, and pay attention to construction safety.